FLEX-5000 Balanced Line-In to W2IHY Audio Interface Configuration
Content provided by: FlexRadio Systems Engineering & W2IHY
The following wiring diagram represents how to wire the FLEX-5000 Balanced Line-In (1/4" TRS) and PTT to the W2IHY EQplus and the 8-Band EQ using the 5-pin DIN connector.
![]()
NOTE: Connect the GROUND (GND) to the cable shield but do not connect it to the shield of the DIN connector
This KB article may reference additional files that are available on the FlexRadio Systems web site Downloads page. Please use the URL(s) below to download the referenced materials.
An Adobe Acrobat Reader may be required to open the file.You can download Adobe Acrobat from here.![]()
KB Source Document(s):
None Referenced
![]()
| System Dependencies | |
| Minimum PowerSDR Version: | N/A |
| Applicable Hardware: | FLEX-5000 |
Content provided by: FlexRadio Systems Engineering & W2IHY
The following wiring diagram represents how to wire the FLEX-5000 Balanced Line-In (1/4" TRS) and PTT to the W2IHY EQplus and the 8-Band EQ using the 5-pin DIN connector.
NOTE: Connect the GROUND (GND) to the cable shield but do not connect it to the shield of the DIN connector
This KB article may reference additional files that are available on the FlexRadio Systems web site Downloads page. Please use the URL(s) below to download the referenced materials.
An Adobe Acrobat Reader may be required to open the file.You can download Adobe Acrobat from here.
KB Source Document(s):
None Referenced
